The clinical value of preoperative 3D planning and 3D surgical guides for Imhäuser osteotomy in slipped capital femoral epipysis: a retrospective study.

BACKGROUND: Accurate repositioning of the femoral head in patients with Slipped Capital Femoral Epiphysis (SCFE) undergoing Imhäuser osteotomy is very challenging. The objective of this study is to determine if preoperative 3D planning and a 3D-printed surgical guide improve the accuracy of the placement of the femoral head. METHODS: This retrospective study compared outcome parameters of patients who underwent a classic Imhäuser osteotomy from 2009 to 2013 with those who underwent an Imhäuser osteotomy using 3D preoperative planning and 3D-printed surgical guides from 2014 to 2021. The primary endpoint was improvement in Range of Motion (ROM) of the hip. Secondary outcomes were radiographic improvement (Southwick angle), patient-reported clinical outcomes regarding hip and psychosocial complaints assessed with two questionnaires and duration of surgery. RESULTS: In the 14 patients of the 3D group radiographic improvement was slightly greater and duration of surgery was slightly shorter than in the 7 patients of the classis Imhäuser group. No difference was found in the ROM, and patient reported clinical outcomes were slightly less favourable. CONCLUSIONS: Surprisingly we didn't find a significant difference between the two groups. Further research on the use of 3D planning an 3D-printed surgical guides is needed. TRIAL REGISTRATION: Approval for this study was obtained of the local ethics committees of both hospitals.

Evaluation of the use of a specially designed saw to remove penis rings at the emergency department.

Objective: Penile strangulation is a rising problem in emergency departments (ED) and can cause serious medical issues. The removal of a penile ring requires immediate action, but is a difficult task. In this study an in-house specialised designed saw to safely remove penis rings is evaluated. Materials and Methods: To evaluate the use of the penis ring saw we used information from our maintenance management software to evaluate the amount of malfunctions. The evaluation of the experiences in the ED were based on semi-structured interviews with ED employees and with the mechanical engineers that developed and maintain the saw. Results: Since 2013 seven jobs were found regarding to a defect of the saw. All defects were broken saw blades. Four emergency care department employees and two instrumentmakers were interviewed. All four are pleased with the saw, because it improves patient safety during removal of the penis ring. The two instrument makers agree with the ED nurses that the saw is an improvement compared to the previous used solutions. Possible improvements were also suggested. Conclusion: A specialized saw was designed and developed for the removal of penis rings. This saw offers a safe and standardized way to remove the penis rings.

The organizational and clinical impact of integrating bedside equipment to an information system: a systematic literature review of patient data management systems (PDMS).

OBJECTIVE: The introduction of an information system integrated to bedside equipment requires significant financial and resource investment; therefore understanding the potential impact is beneficial for decision-makers. However, no systematic literature reviews (SLRs) focus on this topic. This SLR aims to gather evidence on the impact of the aforementioned system, also known as a patient data management system (PDMS) on both organizational and clinical outcomes. MATERIALS AND METHODS: A literature search was performed using the databases Medline/PubMed and CINHAL for English articles published between January 2000 and December 2012. A quality assessment was performed on articles deemed relevant for the SLR. RESULTS: Eighteen articles were included in the SLR. Sixteen articles investigated the impact of a PDMS on the organizational outcomes, comprising descriptive, quantitative and qualitative studies. A PDMS was found to reduce the charting time, increase the time spent on direct patient care and reduce the occurrence of errors. Only two articles investigated the clinical impact of a PDMS. Both reported an improvement in clinical outcomes when a PDMS was integrated with a clinical decision support system (CDSS). CONCLUSIONS: A PDMS has shown to offer many advantages in both the efficiency and the quality of care delivered to the patient. In addition, a PDMS integrated to a CDSS may improve clinical outcomes, although further studies are required for validation.

Contact heat evoked potentials: normal values and use in small-fiber neuropathy.

INTRODUCTION: Contact heat evoked potentials (CHEPs) may be an objective, non-invasive diagnostic tool in small-fiber neuropathy (SFN). This study establishes normal CHEP values and examines their applicability in SFN patients. METHODS: Standardized CHEPs were administered at the wrist and ankle. The N2 and P2 latencies and N2 -P2 peak-peak amplitude were recorded by electroencephalography. We examined healthy subjects (n = 97), stratified by age and gender, and SFN patients with abnormal intraepidermal nerve fiber density (n = 42). CHEP reproducibility and interobserver values were also investigated. RESULTS: CHEP normative values were determined. There was a 9-16% increase in latency per centimeter of height with increasing age. Amplitudes were higher in women than men, and decreased (17-71%) with aging. Test-retest reproducibility and interobserver values were >0.61 and >0.96, respectively. CHEPs were abnormal in 73.8% of the patients. CONCLUSION: In this study we have established normal values, reliability, and clinical applicability of CHEPs in SFN.

Improving quantitative dosimetry in (177)Lu-DOTATATE SPECT by energy window-based scatter corrections.

PURPOSE: Patient-specific dosimetry of lutetium-177 ((177)Lu)-DOTATATE treatment in neuroendocrine tumours is important, because uptake differs across patients. Single photon emission computer tomography (SPECT)-based dosimetry requires a conversion factor between the obtained counts and the activity, which depends on the collimator type, the utilized energy windows and the applied scatter correction techniques. In this study, energy window subtraction-based scatter correction methods are compared experimentally and quantitatively. MATERIALS AND METHODS: (177)Lu SPECT images of a phantom with known activity concentration ratio between the uniform background and filled hollow spheres were acquired for three different collimators: low-energy high resolution (LEHR), low-energy general purpose (LEGP) and medium-energy general purpose (MEGP). Counts were collected in several energy windows, and scatter correction was performed by applying different methods such as effective scatter source estimation (ESSE), triple-energy and dual-energy window, double-photopeak window and downscatter correction. The intensity ratio between the spheres and the background was measured and corrected for the partial volume effect and used to compare the performance of the methods. RESULTS: Low-energy collimators combined with 208 keV energy windows give rise to artefacts. For the 113 keV energy window, large differences were observed in the ratios for the spheres. For MEGP collimators with the ESSE correction technique, the measured ratio was close to the real ratio, and the differences between spheres were small. CONCLUSION: For quantitative (177)Lu imaging MEGP collimators are advised. Both energy peaks can be utilized when the ESSE correction technique is applied. The difference between the calculated and the real ratio is less than 10% for both energy windows.

A comparison of different energy window subtraction methods to correct for scatter and downscatter in I-123 SPECT imaging.

OBJECTIVE: One of the main problems in quantification of single photon emission computer tomography imaging is scatter. In iodine-123 (I-123) imaging, both the primary 159 keV photons and photons of higher energies are scattered. In this experimental study, different scatter correction methods, based on energy window subtraction, have been compared with each other. METHODS AND MATERIALS: Iodine-123 single photon emission computed tomography images of a phantom with a known intensity ratio between background and hollow spheres were acquired for three different collimators (low energy high resolution, low energy general purpose, and medium energy general purpose). The hollow spheres were filled with a higher activity concentration than the uniform background activity concentration, resulting in hot spots. Counts were collected in different energy windows, and scatter correction was performed by applying different methods such as effective scatter source estimation, triple and dual energy window (TEW and DEW), double peak window (DPW) and downscatter correction. The intensity ratio between the spheres and the background was used to compare the performance of the different methods. RESULTS: The results revealed that the efficiency of the scatter correction techniques vary depending on the collimator used. For the low energy high resolution collimator, all correction methods except the effective scatter source estimation and the DPW perform well. For the medium energy general purpose collimator, even without scatter correction, the calculated ratio is close to the real ratio. The DEW and DPW methods tend to overestimate the ratio. For the low energy general purpose collimator, only the DEW and the combined DEW and downscatter correction methods perform well. CONCLUSION: The only correction method that provides a ratio that differs by less than 5% from the real ratio for all the collimators is the combined DEW and downscatter correction method.

Feasibility of adequate dose coverage in permanent prostate brachytherapy using divergent needle insertion methods.

BACKGROUND AND PURPOSE: The purpose of this study is to investigate the feasibility of adequate dose coverage in permanent prostate brachytherapy using divergent needle insertion methods. These methods can be useful in magnetic resonance imaging (MRI) guided needle insertion techniques to avoid pubic arch interference. METHODS AND MATERIALS: MRI data were collected from 10 patients with T1-T2 prostate cancer. An inverse planning algorithm based on simulated annealing was used to optimize the dose distribution for three needle insertion methods: divergent needles with a single rotation point, divergent needles with a double rotation point, and current parallel needle insertion method. The dose constraints were based on our clinical criteria and the recent ESTRO/EAU/EORTC recommendations. RESULTS: If the planning target volume (PTV) surrounded the prostate and only intraprostatic seeds were allowed, the mean PTV volume that received 100% of the prescribed dose (V(100)) was 99% for all needle insertion methods. If the PTV was increased to the prostate with a 3mm margin, the mean PTV V(100) equalled 94%, 95%, and 94% for the single rotation point, double rotation point and current parallel needle insertion method, respectively. If in the latter case the tips of the seeds were placed 3mm outside the apex and base of the prostate, the mean PTV V(100) was 96% for all needle insertion methods. CONCLUSION: This planning study shows that it is feasible to generate an adequate dose coverage using divergent needle insertion methods.

A new robotic needle insertion method to minimise attendant prostate motion.

BACKGROUND AND PURPOSE: The purpose of this study is to investigate the efficacy of a new needle insertion method (tapping instead of pushing) in reducing attendant tissue motion. This can be useful in applications where tissue motion due to needle insertion is problematic such as e.g. MRI-guided prostate brachytherapy and breast biopsies. In this study we will focus on prostate motion due to needle insertion. MATERIAL AND METHODS: Prostate motion due to needle insertion was measured in 30 patients, who were transperineally implanted with fiducial gold markers for position verification in prostate intensity modulated radiotherapy. In total 32 needles were manually pushed into the prostate and 29 were tapped with a prototype robotic system. The prostate motion in the cranio-caudal direction was measured on the video record of the ultrasound images. Differences in prostate motion between the two needle insertion methods were analysed making use of SPSS. RESULTS: The mean prostate motion was 5.6mm (range 0.3-21.6) when the needle was pushed and 0.9 mm (range 0-2.0) when the needle was tapped into the prostate (p<0.001). CONCLUSION: Prostate motion was significantly less when the needle was tapped into the prostate compared to when the needle was pushed. This result is important for the development of a tapping, MRI-guided, prostate implant robotic system.

Measurement of prostate rotation during insertion of needles for brachytherapy.

BACKGROUND AND PURPOSE: The purpose of this study is to investigate whether prostate rotation due to needle insertion for prostate brachytherapy is predictable and if so, to quantify this rotation, and to see whether locking needles reduce the magnitude of prostate rotation. PATIENTS AND METHODS: The measurements are done at the beginning of the procedure for brachytherapy with a Foley catheter in situ. After a needle is inserted into the prostate, a 3D ultrasound scan is made. Then the seeds are delivered using RAPID Strands (Oncura), and the needle is withdrawn. A second 3D scan is made. The needle and seed positions are determined in these scans. To determine the rotation of the prostate, the angle between the needle and the seed trajectory is calculated. RESULTS: The prostate rotations have been measured in 16 patients, eight without the use of locking needles and eight with locking needles. In total 62 needles were inserted. The maximum rotation was 13.8 degrees and occurred in the coronal plane when no locking needles were used with a significant correlation (P<0.01, R=0.637) between the place of insertion and rotation. It was shown that the method (with or without locking needles) had a significant (P<0.001) influence on the rotation in the coronal plane. Rotations in the sagittal plane ranged from -8.5 degrees to +10.2 degrees without correlation with the insertion point of the needle or the use of locking needles. CONCLUSIONS: This study showed that prostate rotation during needle insertion for prostate brachytherapy is relatively large and unpredictable. Locking needles reduce prostate rotation in the coronal plane, but not in the sagittal plane. Minimising this rotation is necessary for accurate seed delivery, especially when a robotic implantation technique is used.

Detecting temporal lobe seizures from scalp EEG recordings: a comparison of various features.

OBJECTIVE: Sixteen different features are evaluated in their potential ability to detect seizures from scalp EEG recordings containing temporal lobe (TL) seizures. Features include spectral measures, non-linear methods (e.g. zero-crossings), phase synchronization and the recently introduced Brain Symmetry Index (BSI). Besides an individual comparison, several combinations of features are evaluated as well in their potential ability to detect TL seizures. METHODS: Sixteen long-term scalp EEG recordings, containing TL seizures from patients suffering from temporal lobe epilepsy (TLE), were analyzed. For each EEG, all 16 features were determined for successive 10s epochs of the recording. All epochs were labeled by experts for the presence or absence of seizure activity. In addition, triplet combinations of various features were evaluated using pattern recognition tools. Final performance was evaluated by the sensitivity and specificity (False Alarm Rate (FAR)), using ROC curves. RESULTS: In those TL seizures characterized by unilateral epileptiform discharges, the BSI was the best single feature. Except for one low-voltage EEG with many artifacts, the sensitivity found ranged from 0.55 to 0.90 at a FAR of approximately 1/h. Using three features increased the sensitivity to 0.77-0.97. In patients with bilateral electroencephalographic changes, the single best feature most often found was a measure for the number of minima and maxima (mmax) in the recording, yielding sensitivities of approximately 0.30-0.96 at FAR approximately 1/h. Using three features increased the sensitivity to 0.38-0.99, at the same FAR. In various recordings, it was even possible to obtain sensitivities of 0.70-0.95 at a FAR = 0. CONCLUSIONS: The Brain Symmetry Index is the most relevant individual feature to detect electroencephalographic seizure activity in TLE with unilateral epileptiform discharges. In patients with bilateral discharges, mmax performs best. Using a triplet of features significantly improves the performance of the detector. SIGNIFICANCE: Improved seizure detection can improve patient care in both the epilepsy monitoring unit and the intensive care unit.